Pembungkus Kumparan dengan Penandaan Logo: Solusi untuk Industri

Ringkasan Eksekutif

A coil that arrives with an uneven wrap rusts at the gaps, and a coil that arrives without its mark is hard to trace on the customer’s floor. A coil wrapper with logo tape passes printed paper or film tape through the coil eye, so every coil leaves sealed and branded in one cycle. This page covers how the wrapper works, the FPW-300 data, what to watch with printed tape, and how to estimate tape length per coil.

An operator rolls a coil onto the carrier rollers inside a yellow guarded frame. The ring turns through the coil eye and lays printed paper tape over the coil while the rollers rotate it. The control cabinet with its stack light stands beside the wrapper, and the finished coil rolls out fully covered in branded tape.

Daftar Isi

Why coils need a logo wrap

Plain film keeps dust and water out but says nothing about the product. A printed tape repeats the brand and grade over the whole coil, so a coil cut from a bundle can still be identified. It also shows tampering: a torn printed wrap is easy to spot. Buyers of PC strand, wire and strip coils ask for it in their packing specs.

Cara kerja pembungkusnya

  1. Beban: the coil is rolled in onto the carrier rollers; a mainframe height adjustment centres the ring on the coil.
  2. Membungkus: the ring passes logo tape through the eye while the carrier rollers turn the coil.
  3. Tumpang tindih: ring speed against roller speed sets the overlap, so the logo repeats evenly.
  4. Selesai: the tape is cut and the coil is rolled out.

Manual button mode and one-key automatic running are both available, and an E-stop and error light sit on the panel.

Data FPW-300

Barang FHOPE FPW-300 coil wrapper
coil ID 508 – 610 mm
coil OD 600 – 1,200 mm
Lebar gulungan 100 – 300 mm
berat coil 20–1,000 kg
Bahan pengepak PVC, LLDPE, PE, kertas, HDPE
Gulungan material Diameter dalam 50 mm, diameter luar 100–450 mm, lebar 100–150 mm
Tumpang tindih 10% –90%
Daya 1.5 kW, 380 V 50 Hz 3 fase
Pasokan udara 4–6 bar

The FPS-300 steel strip version is the same machine; sizes are adjusted to your coil, and coils outside these ranges are confirmed at quote.

  • Panjang pengulangan: choose a print repeat shorter than the visible tape width per turn, so each lap shows the full logo.
  • Tumpang tindih: at 50% overlap half of each lap is covered; set it so the print stays readable.
  • Ketegangan: paper tape needs lower tension than film, or it tears at the coil edge.
  • arah: print reads along the tape, so it runs around the coil section.

Tape length per coil

Tape length ≈ ring turns × perimeter of the coil section. Ring turns = π × mean diameter ÷ (tape width × (1 − overlap)). For a coil of OD 1,000 mm, ID 600 mm and width 200 mm, the mean diameter is 800 mm, the circumference is about 2,512 mm, and with 100 mm tape at 50% overlap the ring makes about 51 turns. The radial wall is (1,000 − 600) ÷ 2 = 200 mm, so the section perimeter is 2 × (width 200 + wall 200) = 800 mm, so tape use is about 51 × 0.8 = 41 m per coil (example only).

Daftar periksa pemilihan

  1. Diameter dalam (ID), diameter luar (OD), lebar, dan berat kumparan?
  2. Coils per shift?
  3. Logo tape alone, or film first and logo tape over it?
  4. Paper or film tape, and print repeat?
  5. Loading by rolling, crane or forklift trolley?
  6. Weighing and label printing needed?

Safety/keselamatan

We design coil wrappers to EN ISO 12100:2010 for risk assessment, EN 415-10 for packaging machine safety and EN 60204-1 for electrical equipment. The ring is fenced, and the E-stop and error light warn the operator.

Pertanyaan yang Sering Diajukan (FAQ) tentang Teknik

Q: Can it wrap film and logo tape on the same coil? A: Yes, in two passes or with a second head, set per project.

Q: Will paper tape tear? A: Not at the right tension; it is set lower than for film.

Q: What coil weight can be rolled in by hand? A: Light coils only; heavier coils use a loading trolley.

Q: Can weighing and labels be added? A: Yes, a weighing station and label printer can be added after the wrapper.

Langkah selanjutnya

  1. Send your coil sizes, weights and logo tape spec Kirimkan ke info@fhopepack.com.
  2. Kami mengatur the wrapper, loading and tape path.
  3. Kami membalas dalam waktu 24 jam dengan proposal dan penawaran harga.

sumber

  • FHOPE product page: FPS-300 / FPW-300 coil wrapper
  • FHOPE project correspondence on PC strand coil wrapping with logo tape
  • EN ISO 12100:2010; EN 415-10; EN 60204-1
  • The coil wrapper shown above

Terakhir ditinjau: 20-10-2026

Pos terkait

Pesan Panggilan
Pesan Panggilan