دستگاه تسمه کشی کویل

خلاصه اجرایی This video shows the handling stage of a coil de-strapping cell: a 6-axis robotic arm lowers its gripper onto a large steel coil, lifts it clear of the floor, repositions it, and carries it toward an inclined conveyor. The strap-cutting or strap-removal action itself is غیر قابل دیدن — the footage covers positioning and transfer only, which matters if you are judging this machine from the video alone. No capacity, cycle time, or safety specification appears anywhere in the frames, so use the video as evidence of the handling method and confirm the rest with the manufacturer.

چیزی که ویدیو نشان می دهد

The embedded video runs about one minute and forty seconds. It follows a single large steel coil through one handling sequence with a white articulated robot arm. There is background music only — no narration — so everything below comes from what the frames show, not from any spoken explanation.

The sequence, timed from the frame record:

• 0: 00-0: 16 — The coil rests stationary on the floor, standing on its edge. The robot arm waits to the right with the gripper hovering above the coil’s top. A grey control cabinet with green LED indicators is visible on the left.
• ۱۰:۰۰–۱۹:۰۰ — The arm lowers and the gripper makes contact with the top edge of the coil, adjusting slightly as it engages.
• ۱۰:۰۰–۱۹:۰۰ — The coil is lifted a short distance off the ground. One frame pass records the coil turning by roughly 10 degrees, then up to about 30 degrees, as the arm repositions it; a later pass reads the coil as staying upright. Treat the rotation figures as approximate — what is consistent is that the coil leaves the floor and moves under the gripper’s control.
• ۱۰:۰۰–۱۹:۰۰ — The arm carries the coil sideways toward a green inclined conveyor on the right of the work zone. The coil stays suspended and stable during the transfer.
• Remainder of the footage — The arm makes small final adjustments with the end-effector resting against the coil’s side. An operator in a red hard hat is visible in the background during the middle of the sequence.

No frame shows a pause, fault, or interruption. Equally important: no frame shows a strap being cut, released, or removed. The video captures the positioning and transport phase of the de-strapping workflow, not the strap-removal moment itself. If you are evaluating this machine, read the footage as a demonstration of the robotic handling method and ask the manufacturer for material showing the cutting stage.

ساختار دستگاه در یک نگاه

The frames support a basic read of the cell’s layout:

Nothing in the footage identifies the machine model. A small plate on the robot arm and partial signage on background equipment are not readable, and no certification mark is visible.

یادداشت‌های مشاهده مستقیم

The block below stays close to the frame-by-frame record so you can check every claim against the video:

• A large black steel coil lies stationary on the floor at the start, standing on its edge with the eye vertical.
• A white industrial robot arm stands to the right, its end-effector hovering above the coil top.
• Around 20–24 s the gripper lowers and contacts the coil’s top edge, with slight adjustment as it engages.
• Around 28–40 s the coil is lifted a short distance off the ground and repositioned; one frame pass records a rotation of roughly 10°, then up to about 30° total, while a later pass reads the coil as remaining upright.
• Around 44–60 s the arm moves the coil toward a green inclined conveyor on the right; the coil remains suspended and stable during the transfer.
• In the remaining sampled frames the arm continues small adjustments with the end-effector against the coil’s side surface.
• An operator wearing a red hard hat appears near far machinery in the middle of the sequence; no interaction with the machine is shown.
• The structure is a green-painted steel framework with overhead gantry, support beams, and yellow safety railings; the robot’s support column is painted blue.
• A grey cabinet with green LED indicators sits on the left; no screen, buttons, or labels are readable.
• A yellow triangular warning symbol with an exclamation mark is visible on the robot base and motor housing.
• No emergency stop, light curtain, or physical guarding around the robot workspace is visible in any frame.
• No strap cutting, tension release, or strap removal appears in any frame.
• Background markings (for example “A-1276” and “1.6/2.0”) are only partially legible; a watermark logo is overlaid on the footage, and no machine nameplate or model number is readable.

آنچه ویدیو نشان نمی‌دهد

This is the most important section for a buyer. The title names a de-strapping machine; the footage shows the handling stage that surrounds it. The gap matters when you compare suppliers, because the hard part of de-strapping — releasing strap tension and cutting safely — is exactly what is not filmed.

Not observable in any frame:

• Strap cutting, tension release, or disposal of the removed strap
• The coil after it reaches the conveyor, and what the next stage is
• Rated lifting capacity, maximum coil weight, and the acceptable outer-diameter and width range
• Cycle time per coil and throughput
• Power rating, voltage, and any hydraulic or pneumatic specifications
• The control interface: no HMI screen, software, or button layout is readable
• Certification marks such as CE or ISO
• Emergency stop placement, light curtains, or interlocked guarding in the work zone
• Whether the gripper is compatible with oiled or scaled coil surfaces

Any of these points can decide a purchase, so carry them forward as questions rather than assumptions.

جایی که این تجهیزات مناسب است

Reading from the footage and standard practice in coil processing (clearly marked as interpretation, not video fact), a robotic de-strapping cell of this type suits plants that move heavy coils between storage and a processing or packing line:

• کارخانه‌های فولاد و مراکز خدماتی, where large coils must be positioned repeatedly before decoiling, slitting, or galvanizing.
• Automotive and appliance supply chains, where coils feed stamping or forming lines and consistent presentation matters.
• Coil packing and strapping lines, where a stable, repeatable hand-off into a conveyor reduces manual handling at the interface between stages.

The visible benefits are qualitative: the arm keeps the coil under positive control from first contact to conveyor hand-off, and the operator stays at a distance from the lifted load. The cautions are equally relevant: a lifted coil has a high center of gravity and significant inertia; a rigid gripper must not damage the strip surface; and no physical barrier is visible between the robot’s workspace and the surrounding floor, so the installed safety layout deserves close attention. Treat these as points to probe, not as measured performance claims — no numbers in the video support speed or capacity conclusions.

سوالاتی که قبل از خرید باید بپرسید

Use this checklist when you contact the manufacturer:

• What is the rated lifting capacity, and what maximum coil weight, outer diameter, and width does the cell accept?
• Is a dedicated strap-cutting or tension-release tool included, or is the robot in the video only the handling unit?
• What is the end-effector type, and is it safe for your coil surface condition (oil, mill scale, covered edges)?
• What cycle time per coil can the system achieve with a coil like yours?
• How does the cell integrate with existing line controls — PLC synchronization, vision guidance, or MES/ERP interfaces?
• What is the full safety package: guarding, light curtains, emergency stops, and conformance to the robot safety standard applicable in your plant?

سوالات متداول

Does the video show straps being cut or removed? No. Every frame shows positioning, lifting, and transfer toward the conveyor. The strap-removal action itself is not filmed, so ask the manufacturer for footage or a live demonstration of the cutting stage.

What kind of gripper does the robot use? The frames show a black multi-fingered gripper at the robot’s wrist. Whether it clamps mechanically or uses vacuum cannot be confirmed from video — check with the manufacturer.

چه اندازه کویل‌هایی را می‌تواند پشتیبانی کند؟ Not shown. The coil in view appears to be roughly two metres in outer diameter by visual comparison with the robot arm and the operator, but frame-to-frame estimates vary and no specification is displayed. Confirm the accepted weight, diameter, and width ranges with the manufacturer.

Is anyone operating the machine in the video? An operator in a red hard hat is visible in the background during part of the sequence, but no interaction with the machine is shown and no control interface is readable. How the cycle is started and supervised should be confirmed with the manufacturer.

چه ویژگی‌های ایمنی قابل مشاهده هستند؟ Yellow railings on elevated platforms and a yellow warning symbol on the robot base. No emergency stop, light curtain, or work-zone guarding is visible in the frames, so the complete safety design is a key question for the manufacturer.

Can this cell connect to an existing coil line? The video shows the coil being carried to an inclined conveyor, which indicates a downstream stage, but nothing about signals, protocols, or line synchronization is visible. Integration requirements need to be discussed with the manufacturer.

خواندن مرتبط

• ماشین آلات تسمه کشی کویل فولادی — strapping equipment for steel coils at different line positions
• خط بسته بندی کویل اتوماتیک — a full-line view of automated coil packing
• خط بسته بندی کویل مسی — packing lines configured for copper coil handling
• دستگاه تسمه اتوماتیک — the strap-applying side of the cycle
• دستگاه بسته بندی کلاف فولادی — wrapping protection for coils after strapping

مرحله بعدی

If your line removes strapping from steel or copper coils and you are weighing robotic handling against manual work, send the manufacturer your coil data — weight, outer diameter, width, surface condition, and the layout around the de-strapping station. Ask for the strap-cutting demonstration that this video does not include, plus the capacity and safety details on the checklist above. You can start that conversation through the صفحه تماس با.

منبع و روش

The embedded video is the sole factual source for this article. It was analyzed frame by frame with a vision model on sampled frames (one frame roughly every four seconds); the video carries background music only, with no narration, so no speech-to-text was used. Dimensions and rotation figures are visual estimates from the frames and are marked as approximate. Watermark and signage text is described neutrally where it cannot be confirmed, and every statement that goes beyond the visible record is labeled as interpretation or flagged for manufacturer confirmation.