Orbital stretch wrapping machine for automatic shrink wrap


Orbital stretch wrapper
Orbital stretch wrapper for wooden, panel, profile


More information: http://www.fhopepack.com/Horizontal_wrapping_machine.html

Orbital stretch wrapping machine SUPPLIER supplied motor controls shall be housed in a standard
motor control center (MCC) enclosure, and shall provide a method for disconnecting
power from each motor circuit, and allow the operating mechanism to be locked in
the open and closed position by padlock. Refer to the Motor Control Center section
of this specification for additional information.


Orbital stretch wrapping machine SUPPLIER supplied control panel(s) shall provide a centrally
located terminal block layout, separated by voltage level, for the purpose of
terminating all field wires to and from the system. All field wires shall terminate on
one side of the terminal blocks.


Any floor mounted or large wall mounted control panel of the Orbital stretch wrapping machine shall have one 120V,
duplex convenience receptacle installed for maintenance. This does not include
outlets used for powering equipment mounted on panel. This type of panel shall also
contain a switched fluorescent strip light on the ceiling, and shall have provisions to
be “cinch” anchored to finish floor or bolted to building steel.

Orbital stretch wrapper for panel
Orbital stretch wrapper for panel



Comments are closed. Posted by: fhopepack on

Tags: , ,