Turn coil upender Machine Hydraulic Relay

BRIEF DESCRIPTION

[0011] Body 1 is really a schematic structure in the creation.

Before switching position, [0012] Figure 2 is a schematic diagram of the workpiece.

[0013] Physique 3 is actually a schematic diagram of your position flip the workpiece.

[0014] Physique 4 is actually a schematic diagram of your workpiece the inverted position.

[0015] Research numeral: 1 – Holder 2 – Forwards ,2-1-arm assistance platter ,2 -2- turning left arm, 3_ front side turn hydraulic cylinder ,3-1-,3-2 piston rod 4 – overturned hydraulic cylinder and 5 – following the boom 6 – top flip hydraulic tube base 7 – overturned hydraulic upender tube base 8 – assistance columns, nine – in the connecting rod 10 – decrease website link 11 – Remaining pallet 12 – Right pallet 13 – Kept roller 14 – part 15 – Proper curler.

Particular embodiments

[0016] Within the following sketches, the upender is going to be further more described using the embodiments:

The upender makes up a framework 1, the first arm 2, a entrance turn 3 hydraulic cylinders, hydraulic cylinders 4 and overturned after left arm 5, the correct aspect from the structure a top change up anddown and respectively, with base 6 and back hydraulic cylinders Change hydraulic tube base 7; stated front and rear left arm 2 were living hinge arm 5 from the rack a midline; flip the leading correct area in the hydraulic tube 3 action hinged front side turn hydraulic cylinder foundation 6, left Actions easy-to-open entrance reduce left arm 2; stated hydraulic cylinder 4 soon after flipping action easy-to-open on immediately after upender in the hydraulic tube base 7, transform kept following the event easy-to-open on the lower end in the arm 5.

[0017] The body 1 includes 4 assist columns 8, the body 1 in the a number of assist columns 8 is set on the ground, between the assist column 8 by way of a attaching rod 9 and the decrease connecting rod 10 are attached, the hooking up rod 9 and lower connecting rod 10 and several support columns 8 to create a stable reliable bit change dock. Both the ends from the linking rod 9 is linked to the remaining dish 11 and also the appropriate platter 12, a still left platter 11 as well as the proper front side plate 12 are widely used to retain the boom 2 along with the back end arm 5. Said top arm 2 includes a spinning arm support dish 2-2 and 1-2, 2-2 attached to the rotary left arm the rear stop from the assist platter 2-1. Explained supporting platter 2-1 is L-, L-item design ensures in both a horizontal condition or perhaps in a top to bottom state can be near to the initially shift left arm 2. 2-2 each finishes of the rotating left arm includes a revolving hole, turning the arm 2-2 might be connected from a swap before the reduced hydraulic tube 3, rotated and driven around the golf hole in the top of the shaft. Once the transform of your prior growth arm 5 2 symmetric composition. Turn the front tube hydraulic cylinder 3, such as 3-1 and 3-2 piston, the piston rod mounted on the tube 3-1 3-2 on the inside. Before flipping the same structure, flip the rear hydraulic cylinder hydraulic cylinder 3 and 4.

Comments are closed. Posted by: stretchwrapping on

Tags: , ,