style orbital stretch wrapper upender machine

Upender
Upender

Technical range for upender:

1. The bottom of pit should be flat and flatness is under 5mm.
Fix 10mm steel plate on shadow area 1 and shadow area 2 by cement.
2. The pit inner surface weight capacity of pit:
n A pit is not less than 5t/㎡
n B pit is not less than 10t/㎡
n C pit is not less than 5t/㎡
n D pit is not less than 10t/㎡
3. About the docking part of A, B, C, D pit, steel angle was adopted on pit and top edge of ground. Fix10mm steel plate on shadow area 1 and 2 by cement. Top surface of steel plate and ground are on the same level.
The steel plate dimensions on shadow area 1 are 650×500×10mm.
The steel plate dimensions on shadow area 2 are 630×500×10mm.
Please refer to layout for specific location.
4. The shadow area 2 is wire groove. The depth of wire groove is 150mm.
5. The above straight edges of pit drawing making C20 chamfering.
6. After the machine is installed, fill in the empty parts around the upender machine with steel plate, to make sure the machine is parallel with ground.